Making a Pancake Holster for the Kimber Solo Carry
- Eric Adams
- Jan 30, 2017
- 1 min read
This video demonstrates my process of making a pancake holster for the Kimber Solo Carry. I start off by making the pattern, including how I dissect the pattern into individual pattern pieces. Then I demonstrate the entire assembly process, from cutting out the leather, to burnishing, sewing, forming, then final finishing.
Please note that this video is not intended to be a teaching video, as I’ve not added any instructional text or voice-over audio. This is purely a demonstration of my process. I intend to produce instructional videos of specific steps as time and necessity arises, as there’s already loads of great videos on YouTube explaining the various steps in more detail.
I enjoyed reading about the detailed process behind making a custom pancake holster and the care that goes into each step. While working on a busy semester, I even searched for i need someone to take my exam because I was struggling to keep up with everything. The article reminded me that good craftsmanship always takes patience and practice. It was an interesting look at traditional skills.
The post was interesting because it focused on the craftsmanship and patience involved in making a custom leather holster rather than rushing the process. I once tried a small leather crafting project, and it taught me how important careful measurements and attention to detail can be. Around that time I also used Programming Assignment Service UK while working through a difficult coding assignment. It reminded me that good results usually come from taking your time and following each step carefully.